Connect Multiple SIMH Network Instances on one Computer
It is a known problem that you can run multiple instances of SIMH simulators on one computer, but cannot connect the network interfaces of those simulators directly.
You can either use multiple computers connected by a LAN to solve this, or do a special network setup.
Unfortunately I can only show you how to do this on Debian Linux, with other Linux distributions it's probably similar. Windows: I don't know, sorry!
You may have to install some packages beforehand one time only (depending on your Debian configuration):
sudo apt install uml-utilities bridge-utils tcpdump
Run the following shell script as root:
#!/bin/sh # Create four virtual tap network interfaces tunctl -t tap0 tunctl -t tap1 tunctl -t tap2 tunctl -t tap3 # Create a virtual bridge brctl addbr br0 brctl setfd br0 0 # Connect the four virtual interfaces to the virtual bridge brctl addif br0 tap0 brctl addif br0 tap1 brctl addif br0 tap2 brctl addif br0 tap3 # Do a minimal configuration for the virtual interfaces ifconfig tap0 0.0.0.0 ifconfig tap1 0.0.0.0 ifconfig tap2 0.0.0.0 ifconfig tap3 0.0.0.0 # Activate the virtual bridge ip link set br0 up # Activate the virtual interfaces ifconfig tap0 up ifconfig tap1 up ifconfig tap2 up ifconfig tap3 up
# Show virtual bridge configuration brctl show # Show interfaces ip link
The settings will not survive a reboot.
This setup connects the four virtual interfaces tap0, tap1, tap2, and tap3 among themselves, but neither to the local computer nor to any other connected computers.
You can watch the network traffic on any of the virtual interfaces with the following command (just replace the interface name):
tcpdump -i tap0
You must be root to do this or prepend the command with sudo.
Use this SIMH command to attach to e.g. virtual interface tap0, e.g.:
attach xq tap:tap0
See the SIMH 0readme_ethernet.txt for more info on the same topic.
