Difference between revisions of "DD11-B backplane"
From Computer History Wiki
m (Better cat) |
m (→External links: +Engineering Drawings) |
||
| Line 2: | Line 2: | ||
The two [[DEC card form factor|hex-width]] slots were wired to support a [[DF11 Communications Line Adapter]] (in the A-B [[DEC edge connector contact identification|connectors]]) along with a quad-width [[serial line]] [[device controller|interface]], such as the [[DL11 asynchronous serial line interface|DL11]] or the [[DU11 synchronous serial line interface|DU11]]. | The two [[DEC card form factor|hex-width]] slots were wired to support a [[DF11 Communications Line Adapter]] (in the A-B [[DEC edge connector contact identification|connectors]]) along with a quad-width [[serial line]] [[device controller|interface]], such as the [[DL11 asynchronous serial line interface|DL11]] or the [[DU11 synchronous serial line interface|DU11]]. | ||
| + | |||
| + | ==External links== | ||
| + | |||
| + | * [http://www.bitsavers.org/pdf/dec/unibus/DD11-B_RevE_Engineering_Drawings_Feb74.pdf DD11-B Engineering Drawings] | ||
[[Category: UNIBUS Backplanes]]] | [[Category: UNIBUS Backplanes]]] | ||
Latest revision as of 15:15, 27 March 2023
The DD11-B backplane is a 4-slot UNIBUS backplane system unit; it was normally installed in a BA11 mounting box. It used the early 9-pin DEC power distribution connectors.
The two hex-width slots were wired to support a DF11 Communications Line Adapter (in the A-B connectors) along with a quad-width serial line interface, such as the DL11 or the DU11.
