Difference between revisions of "RS64 disk drive"
From Computer History Wiki
(A good start) |
m (clarify) |
||
| Line 29: | Line 29: | ||
The RS64 is a fixed-platter [[fixed-head disk]] [[drive]] used on [[PDP-8 family|PDP-8]]'s and early [[PDP-11]]s. It could store up to 128KB of data in 64 byte blocks. It used 32 fixed read/write [[head]]s for data, and 6 heads to read timing/address [[track]]s (in two duplicated sets of 3, for reliability; switch-over from one set to another was manual). | The RS64 is a fixed-platter [[fixed-head disk]] [[drive]] used on [[PDP-8 family|PDP-8]]'s and early [[PDP-11]]s. It could store up to 128KB of data in 64 byte blocks. It used 32 fixed read/write [[head]]s for data, and 6 heads to read timing/address [[track]]s (in two duplicated sets of 3, for reliability; switch-over from one set to another was manual). | ||
| − | A special device had to be used to write the timing/address tracks. | + | A special device had to be used to write the timing/address tracks. The drive had the ability to write-protect tracks 0-N ('N' set in switches). |
[[Category: DEC Disk Drives]] | [[Category: DEC Disk Drives]] | ||
Revision as of 18:51, 20 November 2018
| RS64 | |
| Manufacturer: | Digital Equipment Corporation |
|---|---|
| Drive Controller(s): | RC11 (UNIBUS) |
| Capacity: | 128KB |
| Transfer Rate: | 125KB/sec (60 Hz), 100KB/sec (50 Hz) |
| Average Access Time: | 16.9msec (60Hz), 20.3msec (50Hz) |
| Revolutions per Minute: | ~1800 (60Hz), ~1400 (50Hz) |
| Media: | 10" diameter nickel-cobalt plated surface with proprietary protective coating |
| Total Surfaces: | 1 |
| Tracks per Surface: | 32 |
| Sectors per Track: | 64 |
| Words per Sector: | 32 |
| Density: | 1700 bpi (maximum) |
| Recording Method: | NRZI |
| Physical Size: | 10" (high), 19" (W, D) |
| Weight: | 64 lbs |
| Power Consumption: | 6A (starting), 2.2A (operating) |
The RS64 is a fixed-platter fixed-head disk drive used on PDP-8's and early PDP-11s. It could store up to 128KB of data in 64 byte blocks. It used 32 fixed read/write heads for data, and 6 heads to read timing/address tracks (in two duplicated sets of 3, for reliability; switch-over from one set to another was manual).
A special device had to be used to write the timing/address tracks. The drive had the ability to write-protect tracks 0-N ('N' set in switches).
