Binary-coded decimal - Revision history

Jnc: +cat

2018-12-16T16:30:25Z

+cat

← Older revision		Revision as of 16:30, 16 December 2018
Line 5:		Line 5:

	{{semi-stub}}		{{semi-stub}}

			[[Category: Computer Basics]]

Jnc: Proper cat

2018-10-18T14:33:49Z

Proper cat

← Older revision		Revision as of 14:33, 18 October 2018
Line 4:		Line 4:
	<!-- (although some [[architecture]]s, such as the [[Intel x86]], do include some [[instruction]]s to help). -->		<!-- (although some [[architecture]]s, such as the [[Intel x86]], do include some [[instruction]]s to help). -->

	{{stub}}		{{semi-stub}}

Jnc: Mention hardware/software support

2018-04-01T14:05:06Z

Mention hardware/software support

← Older revision		Revision as of 14:05, 1 April 2018
Line 1:		Line 1:
	'''Binary-coded decimal''' (usually written as '''BCD''') is a way of storing arbitrary-length numbers in decimal base on a binary computer. Each decimal digit is stored as four [[bit]]s, usually two per [[byte]] ('packed'), although sometimes only one per byte ('un-packed'). 4-bit values not needed to encode a decimal digit are often used for other symbols, e.g. '-', to indicate a negative number.		'''Binary-coded decimal''' (usually written as '''BCD''') is a way of storing arbitrary-length numbers in decimal base on a binary computer. Each decimal digit is stored as four [[bit]]s, usually two per [[byte]] ('packed'), although sometimes only one per byte ('un-packed'). 4-bit values not needed to encode a decimal digit are often used for other symbols, e.g. '-', to indicate a negative number.

			On some machines, BCD was supported in the [[hardware]], as a formal data type with [[instruction]]s which could operate on BCD data (sometimes by an optional [[Commercial Instruction Set]]); on other machines, it was done in [[software]], via [[subroutine package]]s.
			<!-- (although some [[architecture]]s, such as the [[Intel x86]], do include some [[instruction]]s to help). -->

	{{stub}}		{{stub}}

Jnc: A start

2018-03-31T14:44:26Z

A start

New page

'''Binary-coded decimal''' (usually written as '''BCD''') is a way of storing arbitrary-length numbers in decimal base on a binary computer. Each decimal digit is stored as four [[bit]]s, usually two per [[byte]] ('packed'), although sometimes only one per byte ('un-packed'). 4-bit values not needed to encode a decimal digit are often used for other symbols, e.g. '-', to indicate a negative number.

{{stub}}