Difference between revisions of "Asynchronous serial line"
(→UART: do separate page)
|Line 23:||Line 23:|
The complete needed to originate and interpret serial line signals, including the serial-parallelconversion, was implemented in one of the first [[MSI]] chips, the Universal Asynchronous Receiver/Transmitter(UART). The circuitry needed to produce the and needed by the particular interface type was outside the chip, so a UART could be used with either EIA or 20mA interfaces.
Latest revision as of 13:30, 18 November 2021
Asynchronous serial lines were the most common interface to computers for many decades; originally they connected printing terminals like the Teletype, and later video terminals such as the VT100. In general, asynchronous serial line interfaces were bi-directional, using separate wires for each direction (although there are counter-examples, such as printers).
There were two different common electrical interface specifications, 20mA current loop serial line interface, and later EIA RS-232 serial line interface, but they both used the same logical interface protocol at a higher layer, and differed only at the physical layer (voltage, current, etc). EIA supported operation through modems, but 20mA was mostly used for local devices.
Characters are sent as sequence (see image, right) of up to four fields: a 1-bit start marker; 5-8 data bits; an optional parity bit; and a stop marker of 1, 1.5 or 2 bits. The speed, data size, and parity must be externally configured into the transmitter and receiver; the stop width is set in the former.
The line starts at idle; when a character is ready to be sent, one 'start' bit of space (confusingly, on an EIA interface, high voltage) marks the start of a character. The data is then sent, one bit at a time, least-significant-bit first. Finally, the appropriate number of 'stop' bits are sent as mark (low voltage on an EIA interface). If no other characters are ready to be sent, the line is then left at idle (space), otherwise the sending of the next character starts immediately, with another start bit.
If the line is held in the 'space' state for longer than a character time, this is called a break condition, and it can be detected by the receiver and sent specially. This is often used to interrupt the computer on the other end of the line from the terminal.
Common settings with 8 data bits, no parity bit, and 1 stop bit; with the required start bit, which leads to a bit-grouping of exactly 10 bits, which makes throughput calculations simple (bits-per-second/10 = characters per second).
Common settings for remote terminals was to force all caps, and only needing 5 bits per character (which did not, however have enough code points to allow for numerals, as well as a complete alphabet - 2^5=32). It was thought that it would speed throughput, but at such low data rates, the savings were not significant.
The complete circuitry needed to originate and interpret serial line signals, including the serial-parallel conversion, was implemented in one of the first MSI chips, the Universal Asynchronous Receiver/Transmitter (UART). The circuitry needed to produce the voltages and currents needed by the particular interface type was outside the chip, so a UART could be used with either EIA or 20mA interfaces.