Difference between revisions of "DD11-B backplane"
From Computer History Wiki
(The basics) |
(DF11 support) |
||
| Line 1: | Line 1: | ||
| − | The '''DD11-B backplane''' is a 4-slot [[UNIBUS]] [[backplane]] [[system unit]] | + | The '''DD11-B backplane''' is a 4-slot [[UNIBUS]] [[backplane]] [[system unit]]; it was normally installed in a [[BA11 mounting boxes|BA11 mounting box]]. It used the early 9-pin [[DEC power distribution connectors]]. |
| + | The two [[DEC card form factor|hex-width]] slots were wired to support a [[DF11 Communications Line Adapter]] (in the A-B [[DEC edge connector contact identification|connectors]]) along with a quad-width [[serial line]] [[device controller|interface]], such as the [[DL11 asynchronous serial line interface|DL11]] or the [[DU11 synchronous serial line interface|DU11]]. | ||
| + | |||
| + | [[Category: UNIBUS]] | ||
[[Category: DEC Hardware]] | [[Category: DEC Hardware]] | ||
Revision as of 19:08, 2 August 2021
The DD11-B backplane is a 4-slot UNIBUS backplane system unit; it was normally installed in a BA11 mounting box. It used the early 9-pin DEC power distribution connectors.
The two hex-width slots were wired to support a DF11 Communications Line Adapter (in the A-B connectors) along with a quad-width serial line interface, such as the DL11 or the DU11.
