Difference between revisions of "M105 Address Selector"
m (Proper cat) |
m (+cats) |
||
| Line 8: | Line 8: | ||
{{semi-stub}} | {{semi-stub}} | ||
| + | |||
| + | [[Category: UNIBUS]] | ||
| + | [[Category: DEC Boards]] | ||
Revision as of 01:52, 14 December 2018
The M105 Address Selector is a DEC FLIP CHIP which implements the 'address selection' function (i.e. detecting when a particular bus cycle is destined for a particular device) for the UNIBUS.
It was used, along with an M782 Interrupt Control, in early PDP-11 device controllers which plugged into an SPC slot. It was also used in a number of early devices which were built out of a custom backplane and a large number of FLIP CHIPs, such as the RK11-C. Some later devices which no longer used a large number of small Flip Chips (such as the TMB11) also used it.
The board contained a number of jumpers which could be use to set the address to be recognized; the jumpers apply to UNIBUS address bits 3-12. The M105 recognizes any address within a eight byte block; if a device needs more than 4 word registers, the M105 cannot accomplish that.
