MG10 core memory

From Computer History Wiki
Revision as of 03:54, 22 October 2021 by Jnc (talk | contribs) (boards shared with MM11-U)
Jump to: navigation, search

The MG10 was a core main memory system for the PDP-10s, principally the KI10 and early KL10s. An MG10 could contain up to four 32KW memory banks, for a maximum of 128KW (only 1, 2 or 4 bank operation is supported, however). The access time is .67 μseconds maximum, and the cycle time is 1.0 μseconds; parity is provided to protect the memory contents. An MG10 contains a pair of 'controllers', with the controller used for any particular cycle selected by address bit 21.

It was a multi-port memory, with 8 ports per memory system: the CPU uses one port (in a multi-processor system, one per CPU); the others are used by channels (such as a DF10) for mass storage such as disks.

It connected to the so-called external memory bus of the KA (18-bit address) or KI (22-bit address) form. Each port could be independently set to use 18- or 22-bit addresses, or to be disabled. The base address of an MG10 is switch-selectable; that address is used on all the ports, unlike the earlier PDP-10 memories.

The MG10 supports two-way interleaving internally to an MG10, and four-way interleaving between a pair of MG10's (provided they are equally sized); any interleaving applies to all ports. For the two-way case, address bits 21 and 35 are exchanged (recall that the PDP-10 uses big-endian numbering, so bit 35 is the low-order bit), so that all even addresses are handled by controller 0, and odd through controller 1.

The MG10 shares components with the MM11-U core memory of the PDP-11: the G114 sense/inhibit and G235 XY Drive cards; and the H217-B core plane of the MG10 is a 19-bit version of the 18-/16-bit H217-C/D of the MM11-U.

External links