Search results
From Computer History Wiki
Create the page "Disk controller" on this wiki! See also the search results found.
Page title matches
- ...'''RF08 disk controller''' was a [[disk]] [[device controller]] for [[RS08 disk drive]]s on the [[OMNIBUS]] of [[PDP-8 family|PDP-8]]s and [[PDP-12]]s. One * [[DF32 disk controller]]525 bytes (79 words) - 20:26, 6 May 2021
- ...s a [[disk]] [[device controller]] on the [[OMNIBUS]] of PDP-8s for [[DS32 disk drive]]s. One DF32 could handle up to two DS32 drives. It used the [[three * [[RF08 disk controller]]831 bytes (138 words) - 00:50, 30 April 2021
- ...-8 family|PDP-8s]] was for the [[RL01/02 disk drive|RL01 and RL02]] [[disk|disk drive]]s. It could be set under program control to either 8-bit or 12-bit m ...cable runs to the first drive; up to 4 drives can be connected to a single controller, using a bus running from one drive to the next, with a [[terminator]] in t7 KB (982 words) - 21:30, 26 May 2021
- #Redirect [[RL8-A disk controller]]35 bytes (5 words) - 06:15, 27 May 2021
- ...chain (serial) method; thus, there is a separate I/O cable going to each [[disk drive]]. Direct connection of the KDA50 to each drive maximizes subsystem a ...tches host computer [[bus]] capacities to the requirements of high density disk drives. Onboard [[diagnostic]] capability with fault reporting both to the6 KB (888 words) - 10:56, 31 August 2023
- #Redirect [[UDA50 Disk Controller]]35 bytes (4 words) - 01:31, 7 November 2022
- RQDX3 MFM Disk & Floppy QBUS Controller The RQDX3 [[MFM]] Disk & [[Floppy]] [[QBUS]] Controller connect the [[Series of MicroPDP-11 computers]] and the older models of the5 KB (809 words) - 05:06, 5 January 2024
Page text matches
- ...ed for the move was one of the first [[PDP-11/20]]'s built; there was no [[disk]] [[mass storage]] available from [[DEC]] for the machine when it first arr ...the version for which we have the [[source code]] (below), an [[RK11 disk controller|RK11]] had been added; swapping remained on the RF11. The version which we6 KB (926 words) - 19:13, 29 February 2024
- ...under SIMH. Instead you also need a 4.3 BSD system to build the bootable disk to be used for RENO. For the fun of it I re-installed 4.3 then made a copy of the 4.3 disk & put9 KB (1,433 words) - 15:40, 18 August 2009
- [[Image:RF11indicator.jpg|thumb|right|150px|[[RF11 disk controller|RF11]] indicator panel mounted, as usual, at the top of an [[H960 rack|H960 ...essing Unit|CPU]] had such lights; other devices such as [[disk]] [[device controller|controllers]] also had their own indicator panels.4 KB (612 words) - 20:33, 5 January 2024
- the KDB-50 BI disk controller from Chris Torek, and the QVSS + The system has full support for disk labels that con-7 KB (1,067 words) - 04:25, 10 December 2018
- Chapter 6 - Creation of the boot disk .......... 14 Chapter 10 - Modes of TROPIX installation disk91 KB (12,020 words) - 17:55, 13 August 2019
- your system disk and loads the mandatory ULTRIX software subsets. *** SYSTEM DISK SELECTION ***13 KB (1,865 words) - 18:41, 3 July 2022
- X COMPAQ Fast SCSI-2 Controller X COMPAQ 6260 SCSI-2 Controller144 KB (18,526 words) - 03:17, 17 December 2018
- ...an Intel inboard 386 expansion card, nor did it have space to mount a hard disk. ...Amiga 600 (37.299). The Amiga 600 HD variant included a 2.5 inch 40Mb IDE disk, and shipped with the firmware version 37.300 . A later firmware chip was13 KB (2,120 words) - 00:41, 17 December 2018
- The option board included 64KB of RAM, a floppy disk controller and an extra serial port, in addition to the Z80.4 KB (664 words) - 14:34, 11 August 2023
- located in the \i386 directory on Windows NT 3.5 CD-ROM or floppy disk #2 of the EISA X COMPAQ Fast SCSI-2 Controller279 KB (34,581 words) - 03:21, 17 December 2018
- * MASSBUS adaptor with two RP06 disk spindles (176M bytes per spindle) ...Maintenance programs for file system checking, bootstrapping, and physical disk pack handling have also been implemented.49 KB (7,745 words) - 14:29, 6 May 2023
- ...te RAM, two megabytes is recommended; a CGA, EGA or VGA compatible display controller and display; and MS-DOS version 3.1 or later. A COMPAQ DESKPRO 386 configur5 KB (748 words) - 18:06, 13 January 2024
- [[Image:Amiga_A2090_hard_disk_controller.jpg|150px|thumb|right|An A2090 controller]] Technical Notes for Commodore A2090/2090a Hard Disk Controller136 KB (31,870 words) - 21:08, 14 January 2024
- ...per sector, and at the lowest driver levels the system deals with 512 byte disk records. == Making a disk from tape ==42 KB (6,834 words) - 03:01, 17 January 2023
- ...ile does not fit in a 'hole' left by an old deleted file, the files on the disk must be moved together to create a larger area of free space. *DL''n'': RL01 disk cartridge6 KB (830 words) - 23:09, 20 October 2018
- The IBM AT shipped with a WD-1002 [[controller]], that supported MFM hard [[disk]]s, but unlike other controllers, the control code was in the IBM AT, and t ...2" disk on an original AT, if it required a [[ROM]] update, or a 3rd party controller, or both.2 KB (396 words) - 00:41, 20 October 2018
- #Redirect [[RL11 disk controller]]34 bytes (4 words) - 18:51, 10 June 2018
- #Redirect [[RL11 disk controller]]34 bytes (4 words) - 18:51, 10 June 2018
- #Redirect [[RL11 disk controller]]34 bytes (4 words) - 18:52, 10 June 2018
- ...longer used a large number of small Flip Chips (such as the [[TM11 magtape controller|TMB11]]) also used it.5 KB (820 words) - 04:04, 28 November 2023