Search results

Create the page "Category 5 cable" on this wiki! See also the search results found.

• DQ11 NPR Synchronous Line Interface
  |5 || Receive Character Count - RxCC (Secondary) ..., connected to the first one via 3 BC08S [[flat cable]]s connected to M971 Cable Connector cards. (Cards plugged into those slots in the DQ11-AA had to be m
  8 KB (1,222 words) - 04:17, 18 February 2023
• DMV11 Synchronous Controller
  ...tion and checking.) The [[character]] length was [[program]]-selectable to 5-8 [[bit]]s (byte-oriented protocols) or 1-8 bits (bit-oriented). A variety ...ad]] card; [[Berg connector|Berg headers]] on the card connected to [[flat cable]]s which led off to the modem connectors. There were 4 models, the -AP, -BP
  4 KB (508 words) - 03:39, 16 February 2023
• DV11 Communications Multiplexer
  |5 || Receiver Byte Count ...with up to two DV11-BA [[distribution panel]]s (H317-C). Four BC08R [[flat cable]]s connect the main unit to each distribution panel (two for data and [[cl
  6 KB (823 words) - 04:24, 18 February 2023
• ML11 MOS Memory System
  Three dual-width M5903 boards provided the MASSBUS interface; [[flat cable]]s led from [[Berg connector]] headers on the M5903's to the MASSBUS contro | 5 || colspan="6" style="text-align:center;" | M7362 synchronous control
  5 KB (611 words) - 18:24, 14 August 2023
• MM11-W core memory
  | 5 || colspan="6" style="text-align:center;" | G236 X/Y Driver ...the second MM11-U set was added, it was normally installed in slots 1/3/4/5; the order could be reversed, though.
  4 KB (655 words) - 20:02, 30 July 2023
• Alto-1822 Interface
  ...edge of the PCB to a connector on the Alto's back panel, and thence via a cable to the entity to be connected. Both LH and DH 1822 interface variants were .../Alto-1822/extra.dm!1_/.aipcintcable.memo.html Alto-1822 PC Board Internal Cable] May 19, 1978
  3 KB (443 words) - 14:59, 21 May 2023
• DW780 Unibus Adapter
  ...and ii) an M9042 paddle card, which carries the UNIBUS out on three [[flat cable]]s ([[DEC part number]] 70-133622-00), normally to an 'expansion I/O connec ...ation Manual] (EK-SI780-IN-002) - contains a section on the DW780, Chapter 5 (on pp. 40-52 of the PDF)
  2 KB (314 words) - 21:03, 15 May 2024
• RH780 Massbus Adapter
  ...hex M9041 paddle card, which carries the MASSBUS out on three BC06R [[flat cable]]s to what appears to be a standard MASSBUS connector, in an 'expansion I/O [[Category: MASSBUS Controllers]]
  1 KB (213 words) - 21:06, 15 May 2024
• DEC Ethernet Transceivers
  ...00.JPG|400px|thumb|left|DEC H4000 Transceiver with attached Thickwire coax cable]] * You can tap the cable using the removable tapping unit (which is much smaller and lighter than th
  6 KB (955 words) - 17:02, 11 June 2022
• BA23 Enclosure
  ...abinet both BA23 enclosures are connected with a [[BCV2A]] 'Qbus expansion cable and terminator BA23A to BA23C' to provide a large Qbus configuration. The BA23 can hold full-height and half-height 13.3 cm (5.25 in) mass storage devices, depending on the system.
  6 KB (928 words) - 21:57, 19 August 2023
• Booting a real MicroVAX 2000 from an ULTRIX V3.0 DMS Server on a SIMH MicroVAX 3900
  Make sure to use BNC T-connectors at both ends of the coaxial cable and terminate both unused T-connector ports with 50 Ohm terminator plugs: F_..E...D...C...B...A...9...8...7...6...5...4...3_..2_..1...
  5 KB (679 words) - 11:45, 18 July 2022
• DHT32 Asynchronous Serial Line Option
  Connection of one external cable and one H3104 cable concentrator on the MicroVAX 2000, as shown below, enables the connection o After installation of the cable concentrator, your MicroVAX 2000 can accomodate up to twelve terminals.
  3 KB (446 words) - 20:41, 16 August 2022
• CD11 High-Speed Punched Card Reader Control Unit
  * M205 - 5 x 'D' flip-flops * M957 - [[Ribbon cable]] connector
  4 KB (563 words) - 01:45, 3 November 2022
• VAX 8500/8530/8550 Revision Control
  | 3-5 MS88 Memory Arrays ................................... 23... | | | | | | | | Page 5 of 32 | | | | |
  233 KB (10,381 words) - 20:20, 22 May 2023
• VAX 8700/8810 VAX 8800/8820N Revision Control
  | 1-5 Hierarchy, VAX 8700/8800 SYSTEMS..................... 13... | 3-5 87XBA Basic Hardware Group........................... 24...
  239 KB (10,046 words) - 20:25, 22 May 2023
• VAX 8820/8830/8840 Revision Control
  | 3-5 88YBA, System Memory I/O Cabinet..................... 19... ...A3 B3 It is difficult to tighten bottom screw of 17-01545-01 cable. |
  170 KB (7,189 words) - 20:26, 22 May 2023
• ST506 disk interface
  ...g, for several reasons) on that to produce a bit stream, at a data rate of 5 Mbits/sec. Towards the end of its lifetime, [[run-length limited coding|RLL ...hared by up to four disks whereas each disk has got its own dedicated data cable. (Many PC ST506 controllers support only two disk drives.)
  3 KB (523 words) - 17:20, 2 December 2023
• DR780 High-Performance Channel Interface
  ...to an 'External I/O Panel' in the back of the cabinet. From there, a BC06V cable connects to the user equipment. [[Category: DEC Parallel Interfaces]]
  2 KB (349 words) - 20:55, 15 May 2024

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)