Difference between revisions of "Backplane"
m (mention wire-wrap) |
m (→Further reading: 'See also' is canonical) |
||
| (4 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| − | A '''backplane''' is a construct used to connect various components - usually each a single [[PCB]] - of a computer. The backplane contains a number of | + | A '''backplane''' is a construct used to connect various components - usually each a single [[printed circuit board|PCB]] - of a computer. The backplane contains a number of [[connector]]s, mechanically joined to each other, and then wired together; the components are plugged into the connectors. In early backplanes, the electrical connections beween the connectors were hand- or machine-wired (often using [[wire-wrap]]): later, PCBs were often used there, too. |
| − | The connectors often utilize contacts ('lands') on the edge of a PCB; when the edge is plugged into the connector, contacts in the connector touch the lands and complete the circuit. | + | The connectors often utilize contacts ('lands') on the edge of a PCB; when the edge is plugged into the connector, contacts in the connector touch the lands and complete the [[circuit]]. |
In early computers, the components were small, and were only small sub-units (i.e. not a complete [[CPU]] or [[main memory]] unit); later, such entities were built on a single PCB. | In early computers, the components were small, and were only small sub-units (i.e. not a complete [[CPU]] or [[main memory]] unit); later, such entities were built on a single PCB. | ||
| − | {{stub}} | + | {{semi-stub}} |
| + | |||
| + | ==See also== | ||
| + | |||
| + | * [[QBUS backplanes]] | ||
| + | * [[UNIBUS backplanes]] | ||
| + | |||
| + | [[Category: Components]] | ||
Latest revision as of 12:14, 17 August 2024
A backplane is a construct used to connect various components - usually each a single PCB - of a computer. The backplane contains a number of connectors, mechanically joined to each other, and then wired together; the components are plugged into the connectors. In early backplanes, the electrical connections beween the connectors were hand- or machine-wired (often using wire-wrap): later, PCBs were often used there, too.
The connectors often utilize contacts ('lands') on the edge of a PCB; when the edge is plugged into the connector, contacts in the connector touch the lands and complete the circuit.
In early computers, the components were small, and were only small sub-units (i.e. not a complete CPU or main memory unit); later, such entities were built on a single PCB.
