Difference between revisions of "Sync character"
From Computer History Wiki
(Covers the basics) |
m (New cat) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | A '''sync character''' (short for '''synchronization character''') is a special [[character]] used on a [[synchronous serial line]] to keep the [[clock]]s at both ends in synchronization. It is sent when there is no data ready to be sent over the line. If a line is idle, usually several sync characters are sent to allow the receiver to work out where the character boundaries are, before sending the special character(s) which mark the start of a [[frame]]. | + | A '''sync character''' (short for '''synchronization character''') is a special [[character]] used on a [[synchronous serial line]] to keep the [[clock]]s at both ends in synchronization. It is sent when there is no data ready to be sent over the line. If a line is idle, usually several sync characters are sent to allow the receiver to work out where the character boundaries are, before sending the special character(s) which mark the start of a [[communication frame]]. |
{{semi-stub}} | {{semi-stub}} | ||
| − | [[Category: | + | [[Category: Serial Lines]] |
Latest revision as of 14:02, 23 May 2022
A sync character (short for synchronization character) is a special character used on a synchronous serial line to keep the clocks at both ends in synchronization. It is sent when there is no data ready to be sent over the line. If a line is idle, usually several sync characters are sent to allow the receiver to work out where the character boundaries are, before sending the special character(s) which mark the start of a communication frame.
