Difference between revisions of "M782 Interrupt Control"
From Computer History Wiki
(Add earlier versions) |
(Add vector jumpers) |
||
| Line 1: | Line 1: | ||
[[Image:M7821.jpg|150px|thumb|right|M7821 flip chip]] | [[Image:M7821.jpg|150px|thumb|right|M7821 flip chip]] | ||
| − | The '''M782 Interrupt Control''' (later versions M7820 and M7821) is a [[Digital Equipment Corporation|DEC]] [[FLIP CHIP]] which implements the 'interrupt control' function for the [[UNIBUS]]. | + | The '''M782 Interrupt Control''' (later versions M7820 and M7821) is a [[Digital Equipment Corporation|DEC]] [[FLIP CHIP]] which implements the '[[interrupt]] control' function for the [[UNIBUS]]. |
It was used, along with an [[M105 Address Selector]], in early [[PDP-11]] [[device controller]]s which plugged into an [[Small Peripheral Controller|SPC]] slot. It was also used in a number of early devices which were built out of a custom [[backplane]] and a large number of FLIP CHIPs, such as the [[RK11|RK11-C]]. Some later devices which no longer used a large number of small Flip Chips (such as the [[TM11|TMB11]]) also used it. | It was used, along with an [[M105 Address Selector]], in early [[PDP-11]] [[device controller]]s which plugged into an [[Small Peripheral Controller|SPC]] slot. It was also used in a number of early devices which were built out of a custom [[backplane]] and a large number of FLIP CHIPs, such as the [[RK11|RK11-C]]. Some later devices which no longer used a large number of small Flip Chips (such as the [[TM11|TMB11]]) also used it. | ||
| + | |||
| + | The board contained a number of [[jumper]]s which could be use to set the [[interrupt vector]]. | ||
{{stub}} | {{stub}} | ||
Revision as of 04:23, 5 September 2018
The M782 Interrupt Control (later versions M7820 and M7821) is a DEC FLIP CHIP which implements the 'interrupt control' function for the UNIBUS.
It was used, along with an M105 Address Selector, in early PDP-11 device controllers which plugged into an SPC slot. It was also used in a number of early devices which were built out of a custom backplane and a large number of FLIP CHIPs, such as the RK11-C. Some later devices which no longer used a large number of small Flip Chips (such as the TMB11) also used it.
The board contained a number of jumpers which could be use to set the interrupt vector.
