Difference between revisions of "H745 -15V Regulator"
(rm bogosity) |
(ref vi conversion) |
||
| Line 1: | Line 1: | ||
| − | The '''H745 -15V Regulator''' is one of the [[DEC standard modular | + | The '''H745 -15V Regulator''' is one of the [[DEC standard modular regulators]]. It can produce an output [[current]] of up to 10A at an output [[voltage]] of -15V. It has over-current and over-voltage detection and protection. |
| − | It was a [[switching power supply]], one of the earliest; however, the basic concept was somewhat different from later supplies of this type. It takes as input [[alternating current|AC]] at a [[voltage]] of 20V-30V, runs it through a [[diode]] bridge and filter [[capacitor]] to convert it to [[direct current|DC]]. That is then run through | + | It was a [[switching power supply]], one of the earliest; however, the basic concept was somewhat different from later supplies of this type. It takes as input [[alternating current|AC]] at a [[voltage]] of 20V-30V, runs it through a [[diode]] bridge and filter [[capacitor]] to convert it to [[direct current|DC]]. That is then run through a large [[transistor]] controlled by a monolithic [[integrated circuit]] [[voltage regulator]] and an [[inductor]] to do [[VI conversion]] using a [[buck converter]], to produce the output. |
It took its AC input on pins 6 and 8, and it also used +15V input on pins 4 and 5 (why two pins is unclear, since the +15V supply was of limited current); the 15V output was on pin 1, and the [[ground return]] on pins 2 and 3. Pin 7 was not connected. | It took its AC input on pins 6 and 8, and it also used +15V input on pins 4 and 5 (why two pins is unclear, since the +15V supply was of limited current); the 15V output was on pin 1, and the [[ground return]] on pins 2 and 3. Pin 7 was not connected. | ||
Revision as of 02:32, 28 September 2018
The H745 -15V Regulator is one of the DEC standard modular regulators. It can produce an output current of up to 10A at an output voltage of -15V. It has over-current and over-voltage detection and protection.
It was a switching power supply, one of the earliest; however, the basic concept was somewhat different from later supplies of this type. It takes as input AC at a voltage of 20V-30V, runs it through a diode bridge and filter capacitor to convert it to DC. That is then run through a large transistor controlled by a monolithic integrated circuit voltage regulator and an inductor to do VI conversion using a buck converter, to produce the output.
It took its AC input on pins 6 and 8, and it also used +15V input on pins 4 and 5 (why two pins is unclear, since the +15V supply was of limited current); the 15V output was on pin 1, and the ground return on pins 2 and 3. Pin 7 was not connected.
