Difference between revisions of "Serial line"
From Computer History Wiki
(New cat, +→See also) |
m (→Further reading: +Comparison of Data Transmission Techniques) |
||
| Line 15: | Line 15: | ||
* [[EIA RS-232 serial line interface]] | * [[EIA RS-232 serial line interface]] | ||
* [[EIA RS-422 serial line interface]] | * [[EIA RS-422 serial line interface]] | ||
| + | * [[Parallel interface]] | ||
| + | |||
| + | ==Further reading== | ||
| + | |||
| + | * ''Comparison of Data Transmission Techniques'', [[MicroNote]] #021 | ||
[[Category: Communication Basics]] | [[Category: Communication Basics]] | ||
[[Category: Serial Lines]] | [[Category: Serial Lines]] | ||
Latest revision as of 14:41, 27 July 2024
A serial line is a means of transmitting data in bit serial fashion, often over a communication link such as a telephone line. There are two principal forms:
- asynchronous serial lines, in which the format is self-clocking (i.e. the start location of each character can be inferred from the data stream), and
- synchronous serial lines, where each character starts immediately after the previous one, and is therefore not self-clocking
Both serial line protocols requires two signal levels: idle (mark, often high voltage), and asserted (space, often low voltage). (The polarity is a legacy from telegraphy, where the line was held high in order to show that the line was not broken, and that the transmitter was functional.)
If the line is held in the 'asserted' state for longer than a character time, this is called a break condition, and it can be detected by the receiver and signalled to the user specially. This is often used to interrupt the computer on the other end of the line.
See also
- 20mA current loop serial line interface
- EIA RS-232 serial line interface
- EIA RS-422 serial line interface
- Parallel interface
Further reading
- Comparison of Data Transmission Techniques, MicroNote #021
