M105 Address Selector: Difference between revisions
m →External links: typo |
m →External links: Vince Slyngstad's site has been reorganized a bit; Bitsavers has reorganized a bit |
||
| Line 11: | Line 11: | ||
==External links== | ==External links== | ||
* [http://www.bitsavers.org/pdf/dec/pdp11/handbooks/ | * [http://www.bitsavers.org/pdf/dec/pdp11/handbooks/PDP-11_PeripheralsHbk_1972.pdf pdp11 peripherals and interfacing handbook (1972 edition)] - the M105 is covered on pp. 213-215 (pp. 223-225 of the PDF) | ||
* [http://so-much-stuff.com/pdp8/flipchip/ | * [http://so-much-stuff.com/pdp8/flipchip/flipchip.php FlipChip Modules] - Images and engineering drawings for FLIP CHIP modules | ||
** [http:// | ** [http://so-much-stuff.com/pdp8/trunk/Eagle/projects/DEC/Mxxx/M105/ M105] | ||
[[Category: UNIBUS]] | [[Category: UNIBUS]] | ||
[[Category: DEC Boards]] | [[Category: DEC Boards]] | ||
Latest revision as of 09:52, 8 October 2026
The M105 Address Selector is a DEC FLIP CHIP which implements the 'address selection' function (i.e. detecting when a particular bus cycle is destined for a particular device) for the UNIBUS.
It was used, along with an M782 Interrupt Control, in early PDP-11 device controllers which plugged into an SPC slot. It was also used in a number of early devices which were built out of a custom backplane and a large number of FLIP CHIPs, such as the RK11-C. Some later devices which no longer used a large number of small Flip Chips (such as the TMB11) also used it.
The board contained a number of jumpers which could be use to set the address to be recognized; the jumpers apply to UNIBUS address bits 3-12. The M105 recognizes any address within a eight byte block; if a device needs more than 4 word registers, the M105 cannot accomplish that.
External links
- pdp11 peripherals and interfacing handbook (1972 edition) - the M105 is covered on pp. 213-215 (pp. 223-225 of the PDF)
- FlipChip Modules - Images and engineering drawings for FLIP CHIP modules
