Difference between revisions of "TM10 Magnetic Tape Control"

Revision as of 15:22, 25 October 2022

The TM10 Magnetic Tape Control was the magnetic tape controller for the early PDP-10 models (KA10 and KI10) which had the PDP-10 I/O Bus as a standard bus.

It connected to TU20 and TU79 magnetic tape drives, and the TU10 in 'Slave' configuration.

There were two versions, the TM10A and TM10B; the latter used the DF10 Data Channel for data transfers, to reduce the load on the CPU.

This article is not as complete coverage of the topic as it could be. You can help by expanding it.

Revision as of 01:03, 28 May 2022 (view source) Jnc (talk \| contribs) m (→‎External links: +Manual, EngDrws) ← Older edit		Revision as of 15:22, 25 October 2022 (view source) Jnc (talk \| contribs) m (link to new page) Newer edit →
Line 1:		Line 1:
−	The '''TM10 Magnetic Tape Control''' was the [[magnetic tape controller]] for the early [[PDP-10]] models ([[KA10]] and [[KI10]]) which had the PDP-10 ~~[[input/output\|~~I/O~~]] [[bus~~]] as a standard bus.	+	The '''TM10 Magnetic Tape Control''' was the [[magnetic tape controller]] for the early [[PDP-10]] models ([[KA10]] and [[KI10]]) which had the [[PDP-10 I/O Bus]] as a standard bus.

	It connected to [[TU20]] and [[TU79]] [[magnetic tape drive]]s, and the [[TU10 magtape drive\|TU10]] in 'Slave' configuration.		It connected to [[TU20]] and [[TU79]] [[magnetic tape drive]]s, and the [[TU10 magtape drive\|TU10]] in 'Slave' configuration.