Difference between revisions of "Transistor-transistor logic"
m (add link) |
(Add internal details) |
||
| Line 1: | Line 1: | ||
| − | ''' | + | '''Transistor-transistor logic''' is the circuit type inside the most widespread early [[integrated circuit]] family, the [[74 series]]; it replaced the earlier [[diode–transistor logic]]. |
| + | |||
| + | The name is derived from the fact that both logic as well as signal-amplification were performed by [[transistor]]s; also, most [[gate]]s are composed of one or more transistors. | ||
| + | |||
| + | ==Operation== | ||
| + | |||
| + | In TTL, gates produce low outputs by sinking [[current]] to ground (drawing it in through the output, seemingly paradoxically): the [[transistor|collector]] of the gate's output transistor is connected to the gate's output, and the [[transistor|emitter]] to ground, and when the gate is on, current flows through the transistor to ground. When the gate is off, the output is pulled up via a [[resistor]] connected to the supply voltage. | ||
| + | |||
| + | Use of a smaller pull-up resistor results in a gate which can switch faster, but draws more power; similarly a larger one produces a transistor that is slower, but uses less power. These approaches are used in the 74H and 74L TTL families, respectively. | ||
| + | |||
| + | One sub-set of TTL uses a pair of transistors in a so-called 'totem pole' arrangement, with the collector of one attached to the supply voltage, the emitter of the other attached to ground, and the remaining emitter and collector both connected to the output. The two are then driven by the desired logic signal and its negation. This produced a chip which has symmetric high->low and low->high switching. | ||
| + | |||
| + | ==Applications== | ||
The earliest TTL chips are classed as [[SSI]], but eventually TTL chips ranged up to the largest [[MSI]]. Building larger chips out of TTL was not feasible, as TTL logic tends to dissipate fairly large amounts of heat, which is what led to its eventual superceding by [[Metal Oxide Semiconductor|MOS]]. | The earliest TTL chips are classed as [[SSI]], but eventually TTL chips ranged up to the largest [[MSI]]. Building larger chips out of TTL was not feasible, as TTL logic tends to dissipate fairly large amounts of heat, which is what led to its eventual superceding by [[Metal Oxide Semiconductor|MOS]]. | ||
| − | + | Most computers from the late 1960s through to the middle 1970s were produced entirely in TTL (although its use in such ways continued until the early 1980s - e.g. the [[IBM 3081]] was built out of TTL), and TTL continued to be widely used for the 'glue' logic between larger [[VLSI]] chips until the 1990s, when the lower voltages used with most [[CMOS]] made them obsolete. | |
| − | |||
| − | Most computers from the late 1960s through to the middle 1970s were produced entirely in TTL (although its use in such ways continued until the early 1980s - e.g. the [[IBM 3081]] was built out of TTL), and TTL continued to be widely used for the 'glue' logic between larger [[VLSI]] chips until the 1990s, when the lower voltages used with [[CMOS]] made them obsolete. | ||
==External links== | ==External links== | ||
* [http://en.wikipedia.org/wiki/Transistor–transistor_logic Transistor–transistor logic TTL article on Wikipedia - has comprehensive coverage of the topic] | * [http://en.wikipedia.org/wiki/Transistor–transistor_logic Transistor–transistor logic TTL article on Wikipedia - has comprehensive coverage of the topic] | ||
Revision as of 14:44, 27 March 2018
Transistor-transistor logic is the circuit type inside the most widespread early integrated circuit family, the 74 series; it replaced the earlier diode–transistor logic.
The name is derived from the fact that both logic as well as signal-amplification were performed by transistors; also, most gates are composed of one or more transistors.
Operation
In TTL, gates produce low outputs by sinking current to ground (drawing it in through the output, seemingly paradoxically): the collector of the gate's output transistor is connected to the gate's output, and the emitter to ground, and when the gate is on, current flows through the transistor to ground. When the gate is off, the output is pulled up via a resistor connected to the supply voltage.
Use of a smaller pull-up resistor results in a gate which can switch faster, but draws more power; similarly a larger one produces a transistor that is slower, but uses less power. These approaches are used in the 74H and 74L TTL families, respectively.
One sub-set of TTL uses a pair of transistors in a so-called 'totem pole' arrangement, with the collector of one attached to the supply voltage, the emitter of the other attached to ground, and the remaining emitter and collector both connected to the output. The two are then driven by the desired logic signal and its negation. This produced a chip which has symmetric high->low and low->high switching.
Applications
The earliest TTL chips are classed as SSI, but eventually TTL chips ranged up to the largest MSI. Building larger chips out of TTL was not feasible, as TTL logic tends to dissipate fairly large amounts of heat, which is what led to its eventual superceding by MOS.
Most computers from the late 1960s through to the middle 1970s were produced entirely in TTL (although its use in such ways continued until the early 1980s - e.g. the IBM 3081 was built out of TTL), and TTL continued to be widely used for the 'glue' logic between larger VLSI chips until the 1990s, when the lower voltages used with most CMOS made them obsolete.
