Search results

Create the page "Category 5 cable" on this wiki! See also the search results found.

• EIA RS-232 serial line interface
  ...TE's, and female (DB-25S) for all DCE's. That way, if one RS-232 device or cable could plug into another at all, it was guaranteed to be a correct connectio | Clear To Send || CTS || In || 5 || 8
  6 KB (894 words) - 14:53, 23 May 2022
• DEC asynchronous serial line pinout
  ...he BC20N is the EIA [[null modem]] DCE cable, and the BC21B is the EIA DTE cable) are now essentially un-obtainable, but they are relatively easy to make; t ...up Transmit, Receive, and [[Ground]] alone will not produce a functioning cable.
  7 KB (1,240 words) - 01:17, 16 June 2022
• KA11 changes for the KT11-B
  | D-CS-7605961-0-5 || 5 || Bus Interface & Instruction Register - M725 K9 ...s functions, such as memory cycles), and also by an additional cable. That cable carries various other [[signal]]s, mostly internal signals of the KA11 whic
  9 KB (1,637 words) - 18:11, 2 July 2023
• KT11-B Technical Manual
  * AM CLK (5-2): * DST (5-2):
  31 KB (4,983 words) - 18:22, 2 July 2023
• TM11 magtape controller
  | ERR || colspan=2 | DEN8-5 || PCLR || PEVN || colspan=3 | Unit Select || CUR || INT ENB || colspan=2 | The connection to the master drive is a standard dual-width [[BC11-A]] cable, as used for the UNIBUS. This is the pinout for the TM11 (the other two are
  10 KB (1,388 words) - 02:36, 10 February 2024
• PC11 High-Speed Paper-Tape Reader/Punch Control
  [[Image:BC08J.jpg|thumb|250px|right|BC08J cable]] ...Unused || ''BUSY'' || colspan=3 | Unused || ''DONE'' || INT ENB || colspan=5 | Unused || '''RDR ENB'''
  3 KB (405 words) - 08:02, 28 February 2023
• RK11-C disk controller
  ...fferent numbering for some pages, due to a change involving page 18, 'Disk Cable and Termination'. The Double Buffer set includes that page, but numbered it * 17 - Cable Drivers (hand-written gate lower left)
  9 KB (1,351 words) - 14:44, 26 March 2023
• DH11 asynchronous serial line interface
  * character length (5-8 bits) | 5 || colspan="6" style="text-align:center;" | M7289
  10 KB (1,443 words) - 02:27, 19 February 2023
• DR11-B parallel interface
  * M205 - 5 x 'D' [[flip-flop]]s ...a pair of M957 Split-Lug Cable boards, or via an M9760 (dual) Twisted Pair Cable Connector board. The M9680 (dual) board is a loopback test board, which can
  5 KB (766 words) - 03:15, 25 November 2022
• MicroVAX 2000
  * [[RX33]] 5.25" Floppy Drive * [[DHT32 Asynchronous Serial Line Option]] [[#ref_5|[5]]]
  5 KB (595 words) - 17:41, 13 January 2024
• RL11 disk controller
  ...le (round in cross-section, with special locking connectors). (If the flat cable is plugged in the wrong way around, nothing is damaged; the drive merely tu The cable runs from the converter to the first drive; up to 4 drives can be connected
  8 KB (1,160 words) - 02:13, 1 February 2023
• KS10
  | 5 || colspan="6" style="text-align:center;" | Extra M8629 Memory ...in the the 'disk' RH11 section of the 'Module Utilization' chart, Figure 1-5 (page 1-9, 18 of the PDF), in the KS10 Technical Manual (EK-OKS10-TM-002):
  8 KB (1,237 words) - 19:48, 14 July 2023
• TC11 DECtape controller
  | 5 || M784 || M7821 || G736 || M307 * The M904 is the light cable
  5 KB (717 words) - 01:33, 1 March 2023
• TA11 Magnetic Tape Cassette controller
  ...o an [[Small Peripheral Controller|SPC]] slot; a pair of [[BC08-S]] [[flat cable]]s connect the board and drive. All data transfer is via [[programmed I/O]] | 5 || Space Forward File || SFF
  2 KB (245 words) - 01:55, 1 February 2023
• Chaosnet
  ...abit/second Experimental [[Ethernet]], running over [[cable TV]] [[coaxial cable]] (using standard CATV connectors to connect the [[transceiver]]s; not vamp ...workstations developed to run LISP). It was a local network (about 1-2 km cable lengths), without central control (thus “chaos”). It was “cheap, effi
  8 KB (1,211 words) - 16:55, 10 April 2024
• DL10 PDP-11 Data Link
  ...11 side, PDP-11's connected to the DL10 have a special console which has a cable which goes to the DL10, which allows the PDP-10 to start and stop the PDP-1 | 5
  5 KB (664 words) - 17:27, 7 November 2023
• UNIBUS Experimental Ethernet interface
  ...]] on the card to a [[bulkhead connecter]], from where a standard Ethernet cable led to the [[transceiver]]. | Error || colspan=7 | Unused || Done || Int Enb || colspan=5 | Unused || Enable
  4 KB (553 words) - 03:18, 13 January 2024
• KD11-Z CPU
  | 5 || colspan="6" style="text-align:center;" | M7095 Control ...r]]s in its power supply, and the KD11-Z backplane uses unique [[Flexprint cable]]s for power, which go to the special connections (see image).
  4 KB (668 words) - 15:59, 6 February 2024
• PC04/PC05 High-Speed Paper-Tape Reader/Punch
  The cable arrangements for the '04 and '05 are almost as complicated as the model/ver [[Image:BC08J.jpg|thumb|250px|right|BC08J cable]]
  10 KB (1,588 words) - 08:14, 28 February 2023
• 861 Power Controller
  ...designed to fit into a 19" cabinets such as an [[H960 rack]], and required 5-1/4" of rack space. * 861-D - 110V three-phase, 5-prong twist plug NEMA L21-30P
  1 KB (176 words) - 04:14, 16 June 2022

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)