Difference between revisions of "DEC edge connector contact identification"
(Created page with "The edge connector contact groups of DEC cards such as FLIP CHIPs (often called 'rows', in DEC documentation) on the edge of a DEC card...") |
m (Add see also) |
||
| Line 2: | Line 2: | ||
Within each row, the individual contacts are 'numbered' from the [[DEC Alphabet]]; those on the component side are further numbered '1', and those on the solder side (for boards with contacts on both sides - not all do), '2'. I.e. with the board in a horizontal position, as described above, the right-most contact on the top side (i.e. visible) would be identified as 'AA1'. | Within each row, the individual contacts are 'numbered' from the [[DEC Alphabet]]; those on the component side are further numbered '1', and those on the solder side (for boards with contacts on both sides - not all do), '2'. I.e. with the board in a horizontal position, as described above, the right-most contact on the top side (i.e. visible) would be identified as 'AA1'. | ||
| + | |||
| + | ==See also== | ||
| + | |||
| + | * [[DEC card form factor]] | ||
Revision as of 01:02, 17 December 2017
The edge connector contact groups of DEC cards such as FLIP CHIPs (often called 'rows', in DEC documentation) on the edge of a hex card are 'numbered' A-F, starting from the top (when the card is installed, vertically); this would be the right-hand edge, when the card is horizontal, with the component side up, and the connector 'fingers' toward the viewer. Shorter cards (quads and duals) use subsets of these, starting with 'A'.
Within each row, the individual contacts are 'numbered' from the DEC Alphabet; those on the component side are further numbered '1', and those on the solder side (for boards with contacts on both sides - not all do), '2'. I.e. with the board in a horizontal position, as described above, the right-most contact on the top side (i.e. visible) would be identified as 'AA1'.
