Difference between revisions of "DR11 parallel interface"
From Computer History Wiki
m (DR11-C clone) |
(Split QBUS/UNIBUS) |
||
| Line 1: | Line 1: | ||
| − | The '''DR11s''' were a series of parallel interfaces for the [[UNIBUS | + | The '''DR11s''' were a series of parallel interfaces for the [[UNIBUS]]. Some used [[Direct Memory Access|DMA]], others were [[programmed I/O]]. |
| − | They included | + | They included: |
* [[DR11-A General Device Interface|DR11-A]]: [[programmed I/O]], [[DEC card form factor|quad]] [[Small Peripheral Controller|SPC]] slot | * [[DR11-A General Device Interface|DR11-A]]: [[programmed I/O]], [[DEC card form factor|quad]] [[Small Peripheral Controller|SPC]] slot | ||
| − | * [[DR11-B parallel interface|DR11-B]]: | + | * [[DR11-B parallel interface|DR11-B]]: DMA, 4-slot [[system unit]] |
* [[DR11-C general device interface|DR11-C]]: single-board replacement for the DR11-A | * [[DR11-C general device interface|DR11-C]]: single-board replacement for the DR11-A | ||
| − | * [[DR11-K parallel interface|DR11-K]]: similar functionality to the DR11-C, more robust user interface | + | * [[DR11-K parallel interface|DR11-K]]: similar functionality to the DR11-C, more robust user device interface |
| − | * [[DR11-L | + | * [[DR11-L general-purpose interface|DR11-L]]: double input-only |
| − | * [[DR11-M | + | * [[DR11-M general-purpose interface|DR11-M]]: double output-only |
* [[DR11-W parallel interface|DR11-W]]: [[DEC card form factor|hex]] single-board replacement for the DR11-B | * [[DR11-W parallel interface|DR11-W]]: [[DEC card form factor|hex]] single-board replacement for the DR11-B | ||
| − | + | <!--Almost all use the same interface, except the DRV11-J, which for space reasons uses a different header on the card. --> | |
| + | ==See also== | ||
| − | * [[DRV11 | + | * [[DRV11 parallel interface]] |
| − | |||
| − | |||
| − | |||
| − | + | {{disambiguation}} | |
| − | |||
| − | |||
[[Category:UNIBUS Peripherals]] | [[Category:UNIBUS Peripherals]] | ||
| − | |||
Revision as of 14:16, 13 May 2020
The DR11s were a series of parallel interfaces for the UNIBUS. Some used DMA, others were programmed I/O.
They included:
- DR11-A: programmed I/O, quad SPC slot
- DR11-B: DMA, 4-slot system unit
- DR11-C: single-board replacement for the DR11-A
- DR11-K: similar functionality to the DR11-C, more robust user device interface
- DR11-L: double input-only
- DR11-M: double output-only
- DR11-W: hex single-board replacement for the DR11-B
See also
This disambiguation page lists articles which all may be referred to by the title term.
If an internal link led you here, you may wish to change the link to point directly to the intended article.
