Difference between revisions of "DR11 parallel interface"
From Computer History Wiki
(Split QBUS/UNIBUS) |
(clarify) |
||
| (4 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | The '''DR11s''' were a series of parallel | + | The '''DR11s''' were a series of [[parallel interface]]s for the [[UNIBUS]]. Some used [[Direct Memory Access|DMA]], others were [[programmed I/O]]. |
They included: | They included: | ||
| − | * [[DR11-A General Device Interface|DR11-A]]: [[programmed I/O]], [[DEC card form factor| | + | * [[DR11-A General Device Interface|DR11-A]]: [[programmed I/O]], [[DEC card form factor|dual]] card (in quad [[Small Peripheral Controller|SPC]] slot) |
* [[DR11-B parallel interface|DR11-B]]: DMA, 4-slot [[system unit]] | * [[DR11-B parallel interface|DR11-B]]: DMA, 4-slot [[system unit]] | ||
| − | * [[DR11-C general device interface|DR11-C]]: single-board replacement for the DR11-A | + | * [[DR11-C general device interface|DR11-C]]: quad single-board replacement for the DR11-A |
| − | * [[DR11-K parallel interface|DR11-K]]: similar functionality to the DR11-C, more robust user device interface | + | * [[DR11-K parallel interface|DR11-K]]: hex board with similar functionality to the DR11-C, more robust user device interface |
* [[DR11-L general-purpose interface|DR11-L]]: double input-only | * [[DR11-L general-purpose interface|DR11-L]]: double input-only | ||
* [[DR11-M general-purpose interface|DR11-M]]: double output-only | * [[DR11-M general-purpose interface|DR11-M]]: double output-only | ||
| − | * [[DR11-W | + | * [[DR11-W Direct Memory Access Interface|DR11-W]]: hex single-board replacement for the DR11-B |
<!--Almost all use the same interface, except the DRV11-J, which for space reasons uses a different header on the card. --> | <!--Almost all use the same interface, except the DRV11-J, which for space reasons uses a different header on the card. --> | ||
| Line 18: | Line 18: | ||
{{disambiguation}} | {{disambiguation}} | ||
| − | [[Category:UNIBUS | + | [[Category: UNIBUS Parallel Interfaces]] |
Latest revision as of 22:02, 14 December 2021
The DR11s were a series of parallel interfaces for the UNIBUS. Some used DMA, others were programmed I/O.
They included:
- DR11-A: programmed I/O, dual card (in quad SPC slot)
- DR11-B: DMA, 4-slot system unit
- DR11-C: quad single-board replacement for the DR11-A
- DR11-K: hex board with similar functionality to the DR11-C, more robust user device interface
- DR11-L: double input-only
- DR11-M: double output-only
- DR11-W: hex single-board replacement for the DR11-B
See also
This disambiguation page lists articles which all may be referred to by the title term.
If an internal link led you here, you may wish to change the link to point directly to the intended article.
