Difference between revisions of "Small Peripheral Controller"
(Also CR11) |
(clarify grant jumpers) |
||
| Line 9: | Line 9: | ||
==Grants== | ==Grants== | ||
| − | SPC slots were wired to bring all 5 UNIBUS [[bus grant line|grant lines]] through the device; this was performed in rows C (for [[Non-Processor Request|NPG]]) and D (for BGx) | + | SPC slots were wired to bring all 5 UNIBUS [[bus grant line|grant lines]] through the device; this was performed in rows C (for [[Non-Processor Request and Grant|NPG]]) and D (for BGx). |
| − | The | + | The device board generally had a header which routed the grant (and matching request) line for the desired priority level to the [[interrupt]] [[circuit]]ry, and passed the other grant lines through. Un-occupied slots needed to have a [[G727 grant continuity card|G727]] installed. |
| + | |||
| + | The NPG grant line generally had a [[jumper]] on the backplane at each slot (between pins CA1 and CB1), which had to be removed if a [[DMA]] device was plugged into that slot, or installed if one was removed; alternatively, a [[G7273 grant continuity card]] could be installed. | ||
==SPC Extensions== | ==SPC Extensions== | ||
Revision as of 17:18, 17 November 2021
Small Peripheral Controller or SPC was DEC's name for a board slot in the backplanes of UNIBUS PDP-11s into which small device controllers, etc, could be plugged. It was a quad-high slot, occupying rows C-F in a hex slot.
It was originally conceived to hold a dual-height device-specific card, along with single-height M105 Address Selector and M782 Interrupt Control FLIP CHIPs (later, the M7820 and M7821 revisions). (Among the dual-width controllers which did this were the KL11 (M780), the PC11 (M781), the DR11-A (M786), and the CR11 (M829).)
The appropriate UNIBUS signal lines (address, data, etc) were thus wired to the appropriate rows/pins in SPC slots. Other pins were wired to allow the necessary communication between the cards, without requiring cables between them.
It soon became more cost-effective to fabricate an entire device on a single quad card, but the pinout was retained. (For the pinout of an SPC slot, see here.)
Grants
SPC slots were wired to bring all 5 UNIBUS grant lines through the device; this was performed in rows C (for NPG) and D (for BGx).
The device board generally had a header which routed the grant (and matching request) line for the desired priority level to the interrupt circuitry, and passed the other grant lines through. Un-occupied slots needed to have a G727 installed.
The NPG grant line generally had a jumper on the backplane at each slot (between pins CA1 and CB1), which had to be removed if a DMA device was plugged into that slot, or installed if one was removed; alternatively, a G7273 grant continuity card could be installed.
SPC Extensions
On some systems, some SPC pins were recycled for other purposes.
In the PDP-11/04 and PDP-11/34, on the DD11-P backplane which holds the CPU card(s), along with the KY11-LB Programmer's Console (which plugs into an otherwise-standard SPC slot), the CPU and the Programmer's Console do some communication via the backplane. Pins CP1 and CR1 are Halt Request and Halt Grant, respectively; they allow the KY11-B to tell the CPU to halt.
