Difference between revisions of "ULTRIX Remote Installation Service"
(New page "Ultrix Remote Installation Service") |
(Category added) |
||
| Line 8: | Line 8: | ||
The RIS server must have a suitable load device for tape media, e.g. a [[TK50]] or a 9-track [[magnetic tape]] drive. | The RIS server must have a suitable load device for tape media, e.g. a [[TK50]] or a 9-track [[magnetic tape]] drive. | ||
| + | |||
| + | All network bootable VAX processors are supported as network installation clients. | ||
== History == | == History == | ||
RIS was introduced with Ultrix V2.0 and carried on to the last Ultrix version 4.5. | RIS was introduced with Ultrix V2.0 and carried on to the last Ultrix version 4.5. | ||
| + | |||
| + | {{stub}} | ||
| + | |||
| + | [[Category: Ultrix]] | ||
Revision as of 15:13, 2 July 2022
Introduction
The Ultrix Remote Installation Service (RIS) allows to install the Ultrix operating system and the Ultrix workstation software over the network.
The system manager uses the remote installation service (ris) utility to transfer the Ultrix subsets from the installation media to a directory on the installation server processor. This directory is the network kit.
The server processor must be running the Ultrix Version 2.0 or higher operating system and should have a minimum of available disk space, e.g. 30 Mbytes for Ultrix V2.0.
The RIS server must have a suitable load device for tape media, e.g. a TK50 or a 9-track magnetic tape drive.
All network bootable VAX processors are supported as network installation clients.
History
RIS was introduced with Ultrix V2.0 and carried on to the last Ultrix version 4.5.
