Difference between revisions of "MXV11-B Multifunction Option Module"
m (New cat) |
m (New cat scheme) |
||
| Line 7: | Line 7: | ||
The board contains 128Kbytes of [[Random Access Memory|RAM]]; it can hold a pair of 2, 4, 8 or 16KB ROMs. | The board contains 128Kbytes of [[Random Access Memory|RAM]]; it can hold a pair of 2, 4, 8 or 16KB ROMs. | ||
| − | [[Category: QBUS | + | [[Category: QBUS Asynchronous Serial Interfaces]] |
| − | |||
[[Category: QBUS Memories]] | [[Category: QBUS Memories]] | ||
[[Category: QBUS ROMs]] | [[Category: QBUS ROMs]] | ||
Revision as of 17:54, 16 February 2023
The MXV11-B Multifunction Option Module is a QBUS dual-height peripheral board (M7195), intended to allow the creation of complete systems in a minimal-sized QBUS backplane. It is very similar to the earlier MXV11-A Multifunction Option Module, except that it is a Q22 device.
It contains two asynchronous serial lines (using the DL11 programming standard), an optional clock, a block of main memory, and some PROM for bootstrap purposes. The serial lines are connected via 10-pin Berg connector headers on the top edge of the card, using the standard DEC asynchronous serial line pinout, and line 1 can be set to halt or boot the machine on a break.
The clock is program compatible with the KW11-L Line Time Clock, but it is not a line time clock, since it cannot be driven from AC wall power; it can be connected to 50Hz, 60Hz, or 800Hz clock signals from a divided-down 20MHz crystal which is also used to provide the clock to the serial lines.
The board contains 128Kbytes of RAM; it can hold a pair of 2, 4, 8 or 16KB ROMs.
