Difference between revisions of "DM11-BA Modem Control Multiplexor"

From Computer History Wiki
Jump to: navigation, search
(+ board img)
(Old on was not plug compatible)
Line 5: Line 5:
 
It is [[program compatible]] with the DM11-BB (although a single DM11-BA only supports 8 lines, unlike the DM11-BB, which handled 16), and is implemented as a single [[DEC card form factor|hex]] [[printed circuit board|board]], the '''M8640'''.
 
It is [[program compatible]] with the DM11-BB (although a single DM11-BA only supports 8 lines, unlike the DM11-BB, which handled 16), and is implemented as a single [[DEC card form factor|hex]] [[printed circuit board|board]], the '''M8640'''.
  
[[Image:H317BUncovered.jpg|thumb|left|300px|H317-B with cover off]]
+
It connects, using two [[flat cable]]s plugged into [[Berg connector|Berg headers]] on the board, to a passive distribution panel; either the H317-M or the functionally identical H317-P (the latter has improved [[Interference|EMI]] shielding).
 
 
It connects, using two [[flat cable]]s plugged into [[Berg connector|Berg headers]] on the board, to a passive distribution panel; either one usable with the DM11-BB (such as the H317-B), or the newer H317-M or the functionally identical H317-P (the latter has improved [[Interference|EMI]] shielding).
 
  
 
[[Category: UNIBUS Serial Interfaces]]
 
[[Category: UNIBUS Serial Interfaces]]

Revision as of 15:59, 27 December 2020

DM11-BA M8640 board

The DM11-BA Modem Control Multiplexor allows asynchronous serial lines connected to a UNIBUS device controller to be connected to modems. It could be set to interrupt the CPU when a modem control line (Ring, Carrier, etc) changed state. It is a re-implementation of the DM11-BB Modem Control Option; instead of plugging into a controller backplane like the -BB, the -BA plugs into a standard UNIBUS MUD slot.

It is program compatible with the DM11-BB (although a single DM11-BA only supports 8 lines, unlike the DM11-BB, which handled 16), and is implemented as a single hex board, the M8640.

It connects, using two flat cables plugged into Berg headers on the board, to a passive distribution panel; either the H317-M or the functionally identical H317-P (the latter has improved EMI shielding).