Difference between revisions of "DR11-C general device interface"

From Computer History Wiki
Jump to: navigation, search
(Fairly complete)
 
(+image)
Line 1: Line 1:
 +
[[Image:DR11-C.jpeg|thumb|200px|right|DR11-C board]]
 +
 
The '''DR11-C general device interface''' was a [[UNIBUS]] [[device controller]] which provided a pair of 16-[[bit]] parallel ports, one input, and one output. It was a [[DEC card form factor|quad]] format card (M7860), and used an [[Small Peripheral Controller|SPC]] slot; it used [[programmed I/O]].
 
The '''DR11-C general device interface''' was a [[UNIBUS]] [[device controller]] which provided a pair of 16-[[bit]] parallel ports, one input, and one output. It was a [[DEC card form factor|quad]] format card (M7860), and used an [[Small Peripheral Controller|SPC]] slot; it used [[programmed I/O]].
  

Revision as of 02:32, 26 February 2019

DR11-C board

The DR11-C general device interface was a UNIBUS device controller which provided a pair of 16-bit parallel ports, one input, and one output. It was a quad format card (M7860), and used an SPC slot; it used programmed I/O.

Connection to the user's device is via a pair of 40-pin Berg connectors. A pair of optional single-width paddle cards (M971) may be connected via flat cables.

The DR11-C is the replacement for the earlier multi-board DR11-A General Device Interface. The DR11-C is slightly enhanced over the DR11-A (the -A does not have the CSR1/CSR0 bits).

Registers

The device has three control and buffer registers, which can be configured to any three sequential word locations in the I/O page; the first DR11-C is normally configured to addresses 767770-767774:

Register Abbreviation Address
Control and Status Register DRCSR 767770
Output Buffer Register DROUTBUF 767772
Input Buffer Register DRINBUF 767774

In the register contents (below), bits which are read/write or unused are shown in normal font, those which are read-only are in italics.

Status Register (DRCSR)

REQ B Unused REQ A INT ENB A INT ENB B Unused CSR1 CSR0
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00

Output Buffer Register (DROUTBUF)

OUT15 <-> OUT0
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00

Input Buffer Register (INBUF)

IN15 <-> IN0
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00