DR11-L general-purpose interface

From Computer History Wiki
(Redirected from DR11-L parallel interface)
Jump to: navigation, search
DR11-L board

The DR11-L general-purpose interface was a UNIBUS device controller which provided a pair of 16-bit parallel ports, both input-only. It was a quad format card (M7864), and used an SPC slot; it used programmed I/O.

The DR11-L is roughly an input-only version of the earlier DR11-C general device interface, but is not program compatible with the DR11-C.

Connection to the user's device is via a pair of 40-pin Berg connectors; each is controlled by a separate set of registers (identical for the two connectors). Unlike the DR11-C, data coming in from the user's device is latched in the DR11-L, so may be read at leisure.

Configuration

Another DR11-L board

The device's register and interrupt vector addresses are set by a pair of DIP switches. Unusually for a UNIBUS device, its interrupt priority is also set by the switches. Both the vector and priority may be read in the Control and Status Register.

Registers

The device has two pairs of control and buffer registers, which can be configured to any four sequential word locations in the I/O page; the first DR11-L is normally configured to addresses 764000-76406:

Register Abbreviation Address
Control and Status Register A DRCSRA 764000
Data Buffer Register A DBDBRA 764002
Control and Status Register B DRCSRB 764004
Data Buffer Register B DBDBRB 764006

In the register contents (below), bits which are read/write or unused are shown in normal font, those which are read-only are in italics.

Control and Status Register (DRCSR)

SI Vector SO RQ RQE Prority DR CID DL DAE
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
  • SI - Status In: Signal from user's hardware which can be tested
  • SO - Status Out: Signal to user's hardware
  • RQ - Request: Signal from user's hardware which can be tested, or cause an interrupt
  • RQE - Request Enable: Allows setting RQ to cause an interrupt
  • DR - Data Ready: Monitors the Data Ready In signal
  • CID - CSR ID
  • DL - Data Latch: Set by Data Ready In to signal data has been latched
  • DAE - Data Accepted Enable: Enables Data Accepted Out to user's hardware

Data Buffer Register (DRDBR)

IN15 <-> IN0
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00

Further reading

  • DR11-L/M User Manual (EK-DR11L-OP) - not online
  • DR11-L Field Maintenance Print Set (MP00003) - not online