Difference between revisions of "DR11 parallel interface"
From Computer History Wiki
m (Avoid redirs) |
(Add some more) |
||
| Line 1: | Line 1: | ||
| − | The '''DR11s''' were a series of parallel interfaces for the [[UNIBUS]] and [[QBUS]]. Some used [[Direct Memory Access|DMA]], others were [[programmed I/O]]. | + | The '''DR11s''' were a series of parallel interfaces for the [[UNIBUS]] and [[QBUS]]. Some used [[Direct Memory Access|DMA]], others were [[programmed I/O]]. |
| − | * DR11 (sometimes called the DR11-A): programmed I/O, [[DEC card form factor|quad]] [[Small Peripheral Controller|SPC]] slot | + | They included, for the UNIBUS: |
| − | * [[DR11-B parallel interface|DR11-B]]: DMA, 4-slot [[system unit]] | + | |
| − | * DR11-C: single-board replacement for the DR11-A | + | * [[DR11-A parallel interface|DR11]] (sometimes called the DR11-A): [[programmed I/O]], [[DEC card form factor|quad]] [[Small Peripheral Controller|SPC]] slot |
| − | * DR11-W: [[DEC card form factor|hex]] single-board replacement for the DR11-B | + | * [[DR11-B parallel interface|DR11-B]]: [[Direct Memory Access|DMA]], 4-slot [[system unit]] |
| + | * [[DR11-C parallel interface|DR11-C]]: single-board replacement for the DR11-A | ||
| + | * [[DR11-L parallel interface|DR11-L]]: double input-only | ||
| + | * [[DR11-M parallel interface|DR11-M]]: double output-only | ||
| + | * [[DR11-W parallel interface|DR11-W]]: [[DEC card form factor|hex]] single-board replacement for the DR11-B | ||
and for the QBUS: | and for the QBUS: | ||
| Line 15: | Line 19: | ||
There is also a DRV11-C (M8040), but little is currently known about it. | There is also a DRV11-C (M8040), but little is currently known about it. | ||
| − | + | Almost ll use the same interface, except the DRV11-J, which for space reasons uses a different header on the card. | |
[[Category:UNIBUS Peripherals]] | [[Category:UNIBUS Peripherals]] | ||
[[Category:QBUS Peripherals]] | [[Category:QBUS Peripherals]] | ||
Revision as of 23:51, 15 December 2018
The DR11s were a series of parallel interfaces for the UNIBUS and QBUS. Some used DMA, others were programmed I/O.
They included, for the UNIBUS:
- DR11 (sometimes called the DR11-A): programmed I/O, quad SPC slot
- DR11-B: DMA, 4-slot system unit
- DR11-C: single-board replacement for the DR11-A
- DR11-L: double input-only
- DR11-M: double output-only
- DR11-W: hex single-board replacement for the DR11-B
and for the QBUS:
- DRV11: as for the DR11, on a dual card
- DRV11-J: 4 DRV11's on a dual card
- DRV11-B: DMA, quad card, 18-bit DMA addresses
- DRV11-WA: DMA, dual card, 22-bit DMA addresses
There is also a DRV11-C (M8040), but little is currently known about it.
Almost ll use the same interface, except the DRV11-J, which for space reasons uses a different header on the card.
