Difference between revisions of "BA11-P card cage"
(Short, but has the basics) |
(swing-out mounting) |
||
| Line 1: | Line 1: | ||
The '''BA11-P card cage''' from [[Digital Equipment Corporation|DEC]] was used in [[PDP-11/60]] to hold the [[Central Processing Unit|CPU]], [[main memory]] and [[device controller]]s. | The '''BA11-P card cage''' from [[Digital Equipment Corporation|DEC]] was used in [[PDP-11/60]] to hold the [[Central Processing Unit|CPU]], [[main memory]] and [[device controller]]s. | ||
| − | It held [[DEC card form factor|hex]] [[system unit]] [[backplane]]s, and could contain up to roughly seven standard size (4-slot) system units (the documentation formally specifies six), although the backplane used to hold the CPU was a 14-slot (for the -11/60) unit. | + | It held [[DEC card form factor|hex]] [[system unit]] [[backplane]]s, and could contain up to roughly seven standard size (4-slot) system units (the documentation formally specifies six), although the backplane used to hold the CPU was a 14-slot (for the -11/60) unit. The backplanes were mounted vertically, facing forward (like those in the later [[VAX-11/780]]. |
| − | It was one of the [[BA11 mounting boxes]]. It was mounted in an [[H9500]] double-width low-boy corporate cabinet produced by DEC | + | It was one of the [[BA11 mounting boxes]]. It was mounted in an [[H9500]] double-width low-boy corporate cabinet produced by DEC; the BA11-P's (up to two per M9500) swung out for full access, not on slides as with the other BA11's. |
The BA11-P used one (optionally two) [[H742 Power Supply|H7420 Power Supplies]], which were separate units, permanently mounted directly in the H9500, below and behind the BA11-P; a [[power harness]] connected to the two. The [[power supply]] contained up to five [[DEC standard modular regulators]]; the harness ended in a power distribution panel containing standard [[DEC power distribution connectors]]. | The BA11-P used one (optionally two) [[H742 Power Supply|H7420 Power Supplies]], which were separate units, permanently mounted directly in the H9500, below and behind the BA11-P; a [[power harness]] connected to the two. The [[power supply]] contained up to five [[DEC standard modular regulators]]; the harness ended in a power distribution panel containing standard [[DEC power distribution connectors]]. | ||
Revision as of 16:37, 11 January 2022
The BA11-P card cage from DEC was used in PDP-11/60 to hold the CPU, main memory and device controllers.
It held hex system unit backplanes, and could contain up to roughly seven standard size (4-slot) system units (the documentation formally specifies six), although the backplane used to hold the CPU was a 14-slot (for the -11/60) unit. The backplanes were mounted vertically, facing forward (like those in the later VAX-11/780.
It was one of the BA11 mounting boxes. It was mounted in an H9500 double-width low-boy corporate cabinet produced by DEC; the BA11-P's (up to two per M9500) swung out for full access, not on slides as with the other BA11's.
The BA11-P used one (optionally two) H7420 Power Supplies, which were separate units, permanently mounted directly in the H9500, below and behind the BA11-P; a power harness connected to the two. The power supply contained up to five DEC standard modular regulators; the harness ended in a power distribution panel containing standard DEC power distribution connectors.
External links
- PDP-11/60 cabinet and power supply manual - the BA11-P is covered on pg. 4-7 (pg. 90 of the scanned version) through 4-18
