PDP-10 memories
PDP-10 memories were generally all multi-port memory units. The PDP-10 CPU used one port (one per CPU in multi-processor systems); the others are used by channels for mass storage, such as disks. Interleaving was generally supported between units; usually in pairs, or sometimes groups of four. All the early ones were core, and supported parity for error detection; later ones were MOS DRAM, and used ECC to protect the memory contents.
There were three generations of main memory bus (which ran sequentially through memory units to a terminator), and memory units to attach to them; the first two with the so-called external memory bus, in 18- and 22-bit address forms (for the KA10, and KI10 and early KL10, respectively), and the last with the internal 'S-Bus' (for the later KL10s). (Memory for the KS10, which was sui generis, is not covered here.)
There were minor differences between the two external bus types, requiring a KI10-M Memory Bus Adapter if 18-bit units are to be attached to a KI10. Similarly, 22-bit units can be attached to the S-Bus using a DMA20 Memory Bus Controller.
The S-Bus (and a later version, the X-Bus, used with MOS 'internal' memory) performs memory transfers in blocks of up to four words, so that four words can be read in any cycle; the block can start with any word within the block. The KL10 contains a pair of S-Busses, designated 0 and 1.
Most the memory units had a configuration panel which allowed ports to be enabled, and set the memory's address (often independently for each port); similarly, some level of interleaving could be set.
Memory systems
18-bit external:
22-bit external:
Internal:
The first two groups are all multi-port (generally 4 ports per memory system in the first group, and 8 in the second). The last group were for the later final KL10s (models KL10-E and KL10-R). All except the MF20 and MG20 were core.
