Difference between revisions of "DZV11 asynchronous serial line interface"
Revision as of 04:21, 3 January 2021
The DZV11 was a QBUS four port asynchronous serial line mux card for DEC computers; the QBUS equivalent of the UNIBUS DZ11 (with which it is program compatible). Like the original, it used used programmed I/O, and thus could present a considerable load on the CPU when running a high speed line.
A 64-entry FIFO buffer silo was provided on the input side. The DZV11 could operate with full-duplex modems. It provided program-set baud rates (up to 9600 baud), but not split speed. Break could be detected or generated on each line.
Physically, it was a quad card, the M7957; a cable plugged into a Berg connector header on the card led the lines out of the computer. The pin assignments in the Berg header are mirrored, so that if the mating Berg connector is plugged in backwards, the only result is to invert the line numbering.
Initially, a special BC11U-25 cable was used; it consisted of 4 separate round cables, from a Berg connector, to individual DB25 male connectors (DB-25P) wired as DTEs.
A later alternative to the BC11U consisted of a flat cable from a Berg connector to a distribution panel (DEC part number 70-19964), holding 4 DB25 male connectors. (The distribution panel may be recognized by the part number on its PCB, 50-15419.)
|Control and Status Register||CSR||760100|
|Receiver Buffer Register*||RBUF||760102|
|Line Parameter Register*||LPR||760102|
|Transmit Control Register||TCR||760104|
|Modem Status Register||MSR||760106|
|Transmit Data Register||TDR||760106|
The RBUF and LPR share an address, as do the MSR and TDR: the RBUF is read only, and the LPR is write only; the MSR is read only, and the TDR is write only. Registers marked with a '*' are word-width only, no byte operations.
Control and Status Register (CSR)
- TRDY - Transmitter Ready
- TIE - Transmitter Interrupt Enable
- SA - Silo Alarm
- SAE - Silo Alarm Enable
- Tx Line - Line ready to transmit
- RDONE - Received Done
- RIE - Receiver Interrupt Enable
- MSE - Master Scan Enable
- CLR - Clear input FIFO, CSR and UARTs
- MAINT - Maintenance loopback enabled
Receiver Buffer Register (RBUF)
Line Parameter Register (LPR)
Transmit Control Register (TCR)
Modem Status Register (MSR)
Transmit Data Register (TDR)
- DZV11 User Guide, EK-DZV11-UG-002
- DZV11 Technical Manual, EK-DZV11-TM-001