Difference between revisions of "VAX 9000 series"

From Computer History Wiki
Jump to: navigation, search
m (New category)
m (+New category)
Line 36: Line 36:
 
{{Nav VAX}}
 
{{Nav VAX}}
  
[[Category: Mainframe VAX computers]]
+
[[Category: Mainframe VAX Computers]]
 +
[[Category: VAX Families]]

Revision as of 00:26, 2 January 2024

The VAX 9000 series was a high-performance VAX, described by DEC as a 'mainframe computer'. They were built around a System Control Unit (SCU), which allowed the configuration of tightly-coupled multi-processors with up to 4 CPUs. Main memory was also connected to the SCU.

The CPUs were heavily pipelined, and were built from ECL gate arrays. The performance levels in the line ranged from 30 to 108 VUPs; the VAX 9000s supported vector processing. A 'service processor unit' (SPU) containing four MicroVAX II units acted as a front end; it was primarily tasked with overseeing the operation of the system, e.g. error detection and recovery.

The VAX 9000 used the XMI as its I/O bus; up to 4 were possible in the largest systems. Models in the series included:

The 200 group and the 400 group differ primarily in their physical packaging and available configurations.

Operating systems offered for them included VMS and Ultrix (VAXELN was supported only on the SPU).

Hardware

The CPU was built out of Multi-Chip Units (MCUs). Each CPU was implemented with 13 MCUs, with each MCU containing several ECL macrocell arrays, which contained the CPU logic. The gate arrays were fabricated in Motorola's "MOSAIC III" process, a bipolar process with a drawn width of 1.75 micrometres and three layers of interconnect. The MCUs were installed into a CPU planar module, which accommodated 16 MCUs and was 24 by 24 inches (610 mm) in size.

The 200 group is air-cooled; the 400 group also uses water-cooling.

External links