KA11 CPU

The KA11 is the CPU of the PDP-11/20, the first PDP-11.

It was the only PDP-11 CPU which was not micro-programed (since the cheap ROMs which make micro-programming cost-effective in smaller machines were not available at the time it was designed).

Internal structure

The KA11 is basically divided into four main sections:

• Bus Interface
• Data Paths
• Registers
• Control

The first and last communicate with the machine's main bus, the UNIBUS.

There is a 16x16 register file, of which half are used to hold the machine's general registers; two of the others are used for internal temporary registers (Temp and Source). A number of other internal registers (e.g. the Bus Address Register) are implemented separately, so they are always available.

State machine

As noted above, the KA11 does not have microcode; instead, it uses a state machine to control the operation of the CPU. There are 5 major states:

• Fetch - obtain and decode the instruction;
• Source - decode the source field of a double-operand instruction, fetch the data, and store it in a temporary;
• Destination - decode the destination field, and obtain the data;
• Execute - use the data obtained in previous states to perform the requested operation, including writing data back to the desination;
• Service - perform special operations such as interrupts, traps, etc.

Not all instructions pass through all 5 states, although all do pass through 'Fetch'.

Implementation

The KA11 was implemented as a set of extended length FLIP CHIPs; most of the circuuitry was on quad-height ones, but there were some duals, and a few singles.

They all plugged into a custom backplane, formed from three 4-slot backplane sections wired together into one monolithic unit.

The KA11 board set comprises:

Board	Function
Single
M823	Codes Data
M825	Power Failure and Control
Dual
M224 (two instances)	Data Paths (8 bits; 2 latches, adder)
M225	Registers (16 bits x 16)
M821	Register Control
M822	Flag Control
M824	Priority
Quad
M724	Bus and Console Control
M725	Bus Interface and IR
M726	IR Decode
M727	State Control
M728	Timing and States
M820	Data Path Control