Difference between revisions of "KD11-EA CPU"

From Computer History Wiki
Jump to: navigation, search
(A start, at least)
 
(move maint interface description to KY11-B page)
Line 9: Line 9:
 
Like the [[KD11-E CPU|KD11-E]], it also supported the [[KY11-LB Programmer's Console]], including the maintainence functionality which allowed the CPU's microcode to be [[single-stepping|single-stepped]].
 
Like the [[KD11-E CPU|KD11-E]], it also supported the [[KY11-LB Programmer's Console]], including the maintainence functionality which allowed the CPU's microcode to be [[single-stepping|single-stepped]].
  
The interface to the KY11-LB was carried over two 10-wire cables connected to Berg headers (denominated J1 and J2) on the M8266 module; these carried the [[micro-PC]] (from the CPU), and 'Manual Clock Enable' and 'Manual Clock' lines. The pinout for P1 is the same as for the KD11-E; P2 has additional signals (past uPC08) added in the KD11-EA, though:
+
The interface to the KY11-LB was carried over two 10-wire cables connected to Berg headers (denominated J1 and J2) on the M8266 module. The pinout for P1 is the same as for the KD11-E; P2 has additional signals (other than uPC08) added in the KD11-EA, though:
  
 
J2:
 
J2:

Revision as of 15:36, 1 July 2017

The KD11-EA CPU was the second CPU version for the PDP-11/34; it consisted of two hex boards, the M8265 Data Paths module and the M8266 Control module.

It also supported the optional FP11-A floating point unit and/or the KK11-A cache (it could work with either, or both).

Apparently, the microcode address space was increased by one bit in the KD11-EA over the KD11-E, probably to support the extra micro-code needed for the floating point instructions.

KY11-LB Interface

Like the KD11-E, it also supported the KY11-LB Programmer's Console, including the maintainence functionality which allowed the CPU's microcode to be single-stepped.

The interface to the KY11-LB was carried over two 10-wire cables connected to Berg headers (denominated J1 and J2) on the M8266 module. The pinout for P1 is the same as for the KD11-E; P2 has additional signals (other than uPC08) added in the KD11-EA, though:

J2:

  1. Micro-PC 08
  2. FP11-A Attached
  3. Unused
  4. Unused
  5. Unused
  6. Micro-PC 09
  7. Service Br Power Fail
  8. Load Instruction Register
  9. Power Fail Br Pending
  10. Unused