MM11-E and MM1-F core memories

The MM11-E and MM11-F core memories were UNIBUS main memory units; the first UNIBUS memories produced by DEC. They came out with the first PDP-11, the PDP-11/20.

They were very similar - both 4K word (8K bytes), and most of the boards were in common. The MM11-F was capable of interleaving (although this capability was later made available to the MM11-E as well), and it also had a parity version available, the MM11-FP (which used a 4kx18 core plane instead of the 4Kx16 used in the MM11-E and MM11-F).

The MM11-F was also slightly faster: the MM11-E had an access time of 500 nsec and a cycle time of 1.2 μsec; the MM11-F had an access time of 400 nsec and a cycle time of 980 nsec.

They consisted of a quad H207 (non-parity) or H210 (parity) core plane board, along with a number of dual and single cards, plugged into a quad system unit. The MM11-F and MM11-FP used the same backplane; only the board set was slightly different

Board locations

These are the board locations for the MM11-E and F (as seen from the board side) of the backplane:

Connector	Slot 4	Slot 3	Slot 2	Slot 1
A	UNIBUS Out	Power		UNIBUS In
B		G225%	M109!
C	H207 or H210	G226	G226	G729@ or H7290%
D		G102	G102
E		G102	G102	++
F		G226	G226	G103

++ = G225 (MM11-E) or G108 (MM11-FP)
@ = MM11-E only
% = MM11-F only
! = Possibly the later M1091

The M1091 could be used in the MM11-E as well as the MM11-F; the difference between the M109 and M1091 is the addition of additional jumpers to allow interleaving.